Sidney Sea Wall!

An engineered wall on Robert’s Bay in Sidney.
This project has been a lot of hard work, but is finally getting close to completion!

Here’s a look at the details:

Step 1- Excavation and site prep:

After an initial tear down of existing chunks of concrete we began preparing to dig. Working with an Archeologist to sift through every shovel full that we hand excavated, we had to make sure that the site was not an ancient burial ground. Upon close inspection there were no bones found, only a “braider stone” and honed point made from an animal bone.

This slideshow requires JavaScript.

Then the real fun began!

Step 2: Base and stone wall construction.

Built to engineered specs, we included extra large weepers for the wall drainage and set our lines at the appropriate heights and angles to achieve the 8 to 1 slope ratio on the front face of the wall that is required.

Step 3: Capping and staircase construction

Once the stonework was close to our finished height we began our rollover stone capping to finish the top of the wall cleanly and to highlight the strong feeling of this immense stone structure. The stone staircase is well underway too as Ben works meticulously to set each piece.

Stay tuned for finished product photos!